Minivan / Universal Roof Racks by Vantech - H1 Series
Free Ground Shipping to Anywhere in the lower 48 states in the USA!

Low Profile
ALUMINUM
The Vantech H1 Aluminum system can hold up 600lb (evenly distributed). The Cross bars is 2in x 1in Reinforced extruded aluminum crossbars with internal structural support. The Cross bar is protected by non-slip plastic bar guard on top. Mounting upright are 3mm thick at the base and powder coated. The Mounting uprights are 8in extra wide base at 10.5" total height for the low profile. The Base is welded complete onto upright post for complete seal. There are 4 x 1in eyehooks per mounting upright. Drilling is required to install system onto vehicle. Rubber cap on the upright post prevents wind noise and water leakage. The system Includes 5in ladder stopper to prevent ladder from sliding forward, Ladder stoppers are galvanized and rubber dipped. The system also includes 5.5in ladder guide for easy bungee and tie-down. Ladder guide are galvanized and rubber dipped. Easy turn knob allows quick adjustments and removal of ladder stopper and ladder guide. Velcro straps secure ladders within seconds up to 75 lbs. System powder coated and hardware is galvanized for additional protection against rust.
 
STEEL
The Vantech H1 steel system can hold up 600lb (evenly distributed). The Cross bars is 2in x 1in rectangular 14 gauge heavy duty. The Cross bar is protected by non-slip plastic bar guard on top. Mounting upright are 11 gauge at the base and are galvanized before powder coating. The Mounting uprights are 8in extra wide base at 10.5" total height for the low profile. The Base is welded complete onto upright post for complete seal. There are 4 x 1in eyehooks per mounting upright. Drilling is required to install system onto vehicle. Rubber cap on the upright post prevents wind noise and water leakage. The system Includes 5in ladder stopper to prevent ladder from sliding forward, Ladder stoppers are galvanized and rubber dipped. The system also includes 5.5in ladder guide for easy bungee and tie-down. Ladder guide are galvanized and rubber dipped. Easy turn knob allows quick adjustments and removal of ladder stopper and ladder guide. Velcro straps secure ladders within seconds up to 75 lbs. System powder coated for additional protection against rust.
 

Ladder Guide

Ladder Stopper

Velcro Straps
 
Free Ground Shipping to Anywhere in the lower 48 states in the USA!
Aluminum
H1 Aluminum Universal Van Roof Rack 2 Bar Low Profile 42"-45" - Black H2098B $295.20
H1 Aluminum Universal Van Roof Rack 2 Bar Low Profile 42"-45" - White H2098W $295.20
H1 Aluminum Universal Van Roof Rack 2 Bar Low Profile 56"-60" - Black H2099B $303.20
H1 Aluminum Universal Van Roof Rack 2 Bar Low Profile 56"-60" - White H2099W $303.20
     
Steel
H1 Steel Universal Van Roof Rack 2 Bar Low Profile 42"-45" - Black H2095B $255.20
H1 Steel Universal Van Roof Rack 2 Bar Low Profile 42"-45" - White H2095W $255.20
H1 Steel Universal Van Roof Rack 2 Bar Low Profile 56"-60" - Black H2096B $263.20
H1 Steel Universal Van Roof Rack 2 Bar Low Profile 56"-60" - White H2096W $263.20
     
Optional Accessories
Stage 2 Rivet Nut Kit w/ Rivet Tool (1 Set of 8) 5/16"

Rivet Nuts allow for installation of rack systems without the need to remove interior upholstery. To install rivet nut a hole (same diameter as rivet nut) is first made into the sheet metal. Insert the rivet nut into the hole and using the tool and hex bolt collapse the rivet nut. After the rivet nut is completely collapse remove hex bolt. After installing all rivet nuts the mounts or other accessories can be installed.

This Product Includes:
8X 5/16" Rivet Nut
1 Rivet Nut Tool
8X 5/16" Washer
8X 5/16" Nylon Nut
8X 5/16" Hex Bolt 1 1/2" long

AK059 - Rivet Nut Kit $29.95
EZ Velcro strap Universal with Loop to fit all bars

Easily strap down ladders with the EZ Velcro Strap. Best used with other accessories such as ladder guide, ladder stopper and side supports.

A69 - EZ Velcro Strap $17.95
Vantech 6 inch Clamp on Conduit Carrier for 1 inch X 2 inch cross bars
Product includes:
-1 Front Cap
-1 Rear hatch
-2 U Brackets
-All hardware to mount onto a 1" X 2" cross bar (H1 System)
-6" PVC not included.

A40B - Black $109.95
A40W -White $109.95
A40S - Silver $109.95
Vantech 6 inch Conduit Carrier (Drill Thru)
Product includes:
-1 Front Cap
-1 Rear hatch
-2 U Brackets
-All hardware for a drill thru system
-6" PVC not included

A35B - Black $109.95
A35W -White $109.95
A35S - Silver $109.95
   
Ladder Guide Galvanized (1 inch X 1.5 inch)

Guides make it easier to push ladders or other materials onto roof. Suggested to be used with ladder stoppers and EZ-Velcro Strap. (1 ladder guide)

A01 - Ladder Guide $24.95
Vantech Galvanized Ladder Stopper (1 inch X 1.5 inch)

Ladder Stopper prevent forward, up and down motion of ladders. Suggested to be used with ladder guide and EZ-Velcro Strap (1 ladder stopper)

A05 - Ladder Stopper $24.95
   
 

Truck Cab Protector Pad

Cargo Rack Straps
from ProGrip! 

Secure your Ladders, Pipe, Lumber to your truck rack

 

Click Here for all Vantech Roof and Ladder Racks

Click Here for Main Ladder Racks Page

Our online ordering system will keep all information provided completely secure using SSL encryption technology. Additionally, All information provided by you will be completely confidential. Pickup Specialties does not provide customer information, mailing list or other data to any outside firms or individuals.